
B-63423EN/02 USER PROGRAM 13. PMC CUSTOMIZING TOOLS
-79-
13.2 CHANGING MODE FOR AUTOMATIC OPERATION AND
MACHINING SIMULATION
At the time that an operator push a soft-key for [MEM] or [CHECK],
in order to do a automatic operation or a machining simulation,
MANUAL GUIDE system software will turn the following signal
(DO) to '1'.
R959.0(ANMM) = 1 : Request to change mode to MEM
In response to the above request, PMC program must change mode to
MEM. If this signal turned off to 0 from 1, PMC must change mode to
the old one.
13.3 CHANGING MODE FOR MANUAL OPERATION
At the time that an operator push a soft-key for [HANDLE] or
[TEACH], in order to operate a manual operation, MANUAL GUIDE
system software will turn the following signal (DO) to '1'.
R959.7(JOG) = 1 : Request to change mode to JOG
In response to the above request, PMC program must change mode to
JOG. If this signal turned off to 0 from 1, PMC must change mode to
the old one.