
4.
START-UP MACRO PROGRAM USER PROGRAM B-63423EN/02
-12-
4 START-UP MACRO PROGRAM
Start-up Macro Program is the editing macro program which specifies
the configuration of Manual Guide Screen (Comments in the screen,
Menu, Soft-key, Input dada item, and so on). This program runs only
one time at the time of turning on the power and informs the system
of the configuration about Manual Guide Screen. By setting the data
to the macro variable, the system can know the configuration of
Manual Guide Screen.
4.1 SETTING OF PROGRAM NUMBER AND VARIABLE START
NUMBER
Start-up Macro Program Number and the variable start number which
is used in Start-up Macro Program, are set to the following parameter.
Parameter
Number
Content Standard
Setting
Values
No. 9100 Start-up Macro Program Number 8000
No. 9101 Variable Start Number for Editing Macro
Program
0
NOTE
Usually, there is not need to set the parameter
No.9101. If No.9101 is 0, the system treats the
variable start number as #6020.