
B-63423EN/02 USER PROGRAM 6
. COMMENT OF SOFT-KEYS FOR EACH MENU
-27-
6.2 COMMENT OF SOFT-KEYS IN EDIT FUNCTION MENU
By pushing [EDIT] in the large-classified menu, the edit function
menu below is displayed. In this menu, a selected program can be
edited. The soft-keys in the menu are changed as shown below each
time the rightmost key [+] is pushed.
INIT TOOL MSF COMP POSTIN CONTUR CYCLE TEACH USER RETURN +
MOVE COPY DELETE ALTER O
SEARCH
↑
SEARCH
↓
SEARCH
RETURN +
LIST WRK-CO OFFSET RETURN +
INIT : Definition of work coordinate system, blank
form data
TOOL : Definition of tool data
MSF : Instruction of M, S, F code except G code
COMP : Instruction of cutter or tool length
compensation
POSTIN : Instruction of Line figure (G00, G01)
CYCLE : Definition of canned cycles such as drilling,
milling
TEACH : Creation of programs with handle machining
and auxiliary buttons
USER : Display of user window screens
CONTUR : Instruction of Contour figure ( Line + Circle )
MOVE : Movement of a part of the program
COPY : Copying of a part of the program
DELETE : Deletion of a part of the program
ALTER : Change of a part of the program
O SEARCH : Selection of a program
↑ SEARCH
: Word search in the upward direction
↓ SEARCH
: Word search in the downward direction
LIST, WRK-CO, OFFSET are the same as those in the large-
classified menu, and are omitted in the remainder of this manual.
O701n ;
N0001 (“20 01 C010 20”) (Alphanumeric letters forINIT ) ;
Maximum 6 ch.
N0002 (“20 01 C018 20”) (Alphanumeric letters forTOOL) ;
Maximum 6 ch.
N0003 (“20 01 C020 20”) (Alphanumeric letters for MSF) ;
Maximum 6 ch.
N0004 (“20 01 C028 20”) (Alphanumeric letters forCOMP) ;
Maximum 6 ch.