
13. PMC CUSTOMIZING TOOLS USER PROGRAM B-63423EN/02
-76-
13.1 SIGNALS FOR USER PROGRAMS CALLING
Maximum 20 PMC DI signals are prepared for corresponding User
Program calling. By using these signals as buttons for machine
control function on an operator's panel, proper custom macro
programs, User Programs, will be called and executed.
NOTE
This function is available only at Guidance cutting
operation. If other operation such as ordinary
machining operation is selected, it cannot be used.
1) User Program Number and Corresponding PMC DI Signals
Program No. Calling PMC Signal Function of Program
O9854 R950.4 (TOUT) T-code (T++++, M6)
O9855 R950.5 (M03) Spindle CW (M03)
O9856 R950.6 (M04) Spindle CCW (M04)
O9857 R950.7 (M05) Spindle Stop (M05)
O9858 R951.0 (M08) Coolant On (M08)
O9859 R951.1 (M09) Coolant Off (M09)
O9860 R951.2 (G30) Return to Tool Change Position.
(G30)
O9861 R951.3 (G28) Return to Reference Pos. (G28)
O9862 R951.4 (CLSP9) User Program SUB#9
O9863 R951.5 (CLSP10) User Program SUB#10
O9864 R951.6 (CLSP11) User Program SUB#11
O9865 R951.7 (CLSP12) User Program SUB#12
O9866 R960.0 (CLSP13) User Program SUB#13
O9867 R960.1 (CLSP14) User Program SUB#14
O9868 R960.2 (CLSP15) User Program SUB#15
O9869 R960.3 (CLSP16) User Program SUB#16
O9870 R960.4 (CLSP17) User Program SUB#17
O9871 R960.5 (CLSP18) User Program SUB#18
O9872 R960.6 (CLSP19) User Program SUB#19
O9873 R960.7 (CLSP20) User Program SUB#20
NOTE
In the above PMC signal table, as to actual function
is described signals, User Programs for FANUC
standard specification are prepared.
In these FANUC standard specifications, besides
described machine command outputting, same
command will be inputted into the actual teaching
program, if it is Guidance Machining process.