
B-63423EN/02 USER PROGRAM 6
. COMMENT OF SOFT-KEYS FOR EACH MENU
-37-
6.10 COMMENT OF SOFT-KEYS IN CONTOUR PROFILE MENU
By pushing [CONTUR] in the editing menu, the contour profile menu
below is displayed. In this menu, any contour can be created by
selecting or inputting figures. Intersections and contacts are
automatically calculated. The soft-keys in the menu are changed as
shown below each time the rightmost key [+] is pushed.
START
POINT
LINE CW
ARC
CCW
ARC
CHAMF ROUND END TANGNT RECALC RETURN +
TRANS
COPY
ROTATE
COPY
MIRROR
COPY
RETURN +
LIST WRK-CO OFFSET RETURN +
START POINT : Instructing the start point
LINE : Instructing the line figure
CW ARC : Instructing the clockwise arc figure
CCW ARC : Instructing the counterclockwise arc figure
CHAMF : Instructing the chamfer figure
ROUND : Instructing the round figure
END : Instructing the end of figure
TANGNT : Instructing the tangent
RECALC : Executing the calculation of intersection
TRANS COPY : Translating the specified figure
ROTATE
COPY
: Rotating the specified figure
MIRROR
COPY
: Performing mirror conversion of the specified
figure
NOTE
This user program number O710n is specified to
"Macro program number for displaying Comment of
Contour Profile Menu", which is specified in Start-up
macro program.
O710n ;
N0001 (“20 01 C010 20”) (Alphanumeric letters for START POINT) ;
Maximum 6 ch.
N0002 (“20 01 C018 20”) (Alphanumeric letters for LINE) ;
Maximum 6 ch.
N0003 (“20 01 C020 20”) (Alphanumeric letters for CW ARC) ;
Maximum 6 ch.
N0004 (“20 01 C028 20”) (Alphanumeric letters for CCW ARC) ;
Maximum 6 ch.