
3. CREATING LOADING FILES
USER PROGRAM B-63423EN/02
-10-
3.2 PROCEDURE FOR CREATING LOAD MODULES
As the load module, create a MANUAL GUIDE control module and
load it to the NC system. Also create user modules 1 and 2 if
necessary.
NOTE
5 Without the conclusion of the confidentiality
contract, the load module is provided and the steps
below are not required.
1) Creating a MANUAL GUIDE control module (BJ41.MEM)
<1> Execute MLINK to link object files BJ41.PG1 to BJ41.PG4
and DUMMY.REL included in floppy disks 1 and 2.
c:>MLINK BJ41 [Enter]
Once the linking has completed, ROM file BJ41.ROM is
created. The files to be referenced during the linking must
have been defined in the link control file, because this
linking is performed by referencing the link control file.
Normally, the MTB need not modify the file.
<2> Execute MMCARD to convert the ROM file created in <1>
into a file in memory card format. As a result of the
conversion, load module file BJ41.MEM is created.
c:>MMCARD BJ41 [Enter]
BJ41.ROM
Link (MLINK)
BJ41.PG1 to 4
DUMMY.REL
BJ41.MEM
Convert to MEM file
(MMCARD)
BJ41.ROM
Load to CNC
2) Creating user module 1 (BJ41_U1.MEM)
<1> Execute MCOMP0 to compile source file *.SRC included
in floppy disk 3. (Also compile source file *.SRC in floppy
disk 2 when the measurement cycle option is provided.)
c:>MCOMP0 *.SRC [Enter]
Once the compiling has completed, REL file *.REL is
created. Execute MLINK to link the object file created in