
B-63343EN/02 TYPES OF CYCLE MOTIONS 1.BAR MACHINING (ROUGHING)
- 101 -
1.2 DETAIL OF FIGURE DATA
In Bar machining, up to 30 figures can be specified for one process.
(1) Inputting Start Point
At the top of contour figure, Start Point figure data is placed always.
Figure data window)
START X/Z
Absolute coordinate of figure start point
NOTE
As to Start Point figure data, different from other
figure data such as line or circle whose data are
inputted in a pop-up window, X and Z data are
inputted in a figure data window directly.
(2) Selecting a figure type
A menu of figure type appears in soft-keys. Select a figure type by
pushing the corresponding soft-key.
When a figure has been selected, a pop-up window for inputting
contour figure data appears. Enter the data that is designated on the
blue print.
(3) LINE
END POINT X/Z
Absolute coordinate of figure end point
ANGLE
Angle of line from +Z-axis. A positive angle is clockwise
direction from +Z-axis, and minus angle is counter
clockwise direction.
OVERRIDE
This data is not used in roughing.
X Z;
END POINT X X=
END POINT Z Z=
ANGLE A=
OVERRIDE P=
(X,Z)
CONTOUR FORM
LINE
CALC.
TANGNT
CHAMFARC ROUNDARCLINE