
B-63343EN/02 TYPES OF CYCLE MOTIONS 7.-X AREA CUTTING FUNCTION
- 155 -
7.2 DETAIL OF -X AREA CUTTING
When the -X area cutting is selected, the following transformation are
done against the normal +X area cutting motions, and the result
motions are performed.
(1) X-axis motion command
The signs of all motion commands of X-axis are reversed.
(2) G-codes
G-codes performed in cutting motions are reversed as follows.
G02 -> G03
G03 -> G02
G41 -> G42
G42 -> G41
(3) Machining simulation
According to the -X area cutting motions, a tool used for
animated drawing is displayed in opposite form. And, drawing
for cutting a workpiece which is accompanied with tool motion
is performed in the -X area.
NOTE
When this optional function “-X Area Cutting
Function” is available, animated drawing with a
solid model cannot be used. As the soft-key menu
for machining simulation, only [PATH] and
[ANIMAT+PATH] are displayed, and [ANIMAT] is
never displayed.