
B-63343EN/02 TYPES OF CYCLE MOTIONS 1.BAR MACHINING (ROUGHING)
- 105 -
1.3 DETAIL OF CONTOUR CALCULATION
A figure block, a part of a contour, with its end point not determined
is said to be in the pending state. A pending figure block is drawn by
dotted line.
In the pop-up window for inputting contour figure data, more data
input items than required are provided. These data items are used to
calculate the cross point with the immediately preceding pending
figure block, and also calculate the end point. The pending state is
then released.
NOTE
10 successive figure blocks can be specified as
pending blocks.
(1) CHAMF / ROUND immediately after a start point
Immediately after CHAMF or ROUND, only LINE or ARC can be
inputted.
(2) CHAMF / ROUND at the end of a contour
At the end of a contour, CHAMF or ROUND can be inputted. In this
case, input a dummy figure block as a pending block. In this dummy
block, input only angle data, with its end point pending.
Calculated start point
+Z
+X
CHAMF
Inputted start point
CHAMF
Dummy figure
+Z
+X