
1.BAR MACHINING (ROUGHING) TYPES OF CYCLE MOTIONS B-63343EN/02
- 114 -
(8) Arc that contacts to uncrossing 2 arcs
By inputting 3 successive figure as follows, Arc (2) tangential to 2
arcs , these 2 figures (1) and (3) do not cross, can be specified as the
above drawing. The end points of (1) and (2) will be determined, and
(3) will be pending.
Among 8 arcs possibility, depending on the directions of 2 arcs, the
line that makes a smooth connection to the arcs will be automatically
selected.
1st figure ARC(1) :
Arc with I and K, and it is pending (for which the start
point has been determined)
2nd figure ARC(2) :
No data.
3rd figure ARC(3) :
Arc with R, I and K
R
3
(3)
(1)
R
(2)
Tangential
point
Start point
Center point
(I
3
,K
3
)
Center point
(I
1
,K
1
)
Tangential
point