
B-63343EN/02 TYPES OF CYCLE MOTIONS 7.-X AREA CUTTING FUNCTION
- 153 -
7 -X AREA CUTTING FUNCTION
In the cycle motions of MANUAL GUIDE, as shown in the following
sample drawing, an operator enter cutting figures in the +X area, and
its actual cutting motions are performed in the +X area too.
On the other hand, on the machine which has opposite double tool
posts, there is a case that -X area cutting must be done as follows.
When the optional function “-X Area Cutting Function” is available,
it is possible to select the cutting in +X area or -X area in the cycle
motions excepting hole machining processes. Whether this optional
function is available or not is depending on the machine construction,
so please refer to the manual from the machine tool builder.
+
+Z
Origin of the
Workpiece Coordinate
Workpiece
Origin of Workpiece
Coordinate
+
+Z
Workpiece