
B-63344EN/02 APPENDIX B.ALARMS
- 293 -
B ALARMS
If one or more of the set of the parameters or inputted programs are
not correct when an attempt is made to execute that program, the
following P/S alarms are raised.
When an alarm other than the following P/S alarms is raised, refer to
the relevant NC operator's manual.
Alarm Description
Cause Some initial setting data commonly used for a machining
program is missing. For example, this alarm occurs by the
following mistake.
- No cutting motion in a work-piece was taught-in in a
guidance or single cutting process.
- Incorrect figure data is inputted in cycle motions
Action Delete that program at once, and input it again with regular
figure data or cutting motions.
3000
Reference None
Cause The value of process data such as the machining area, tool
number, or spindle speed is incorrect.
Example) A minus value is entered for an item that must
be positive.
Action On the process data window corresponding to this alarm,
check the entered process data values. If there is an
incorrect value, enter a correct value.
3001
Reference II.4 Guidance Cutting Operations, II.5 Single Cutting
Operations III Types of Cycle Motions
Cause Some figure data is missing.
Action On the figure data window for the process corresponding to
this alarm, check the entered data. If some data is missing,
enter correct data.
3002
Reference III Types of Cycle Motions
Cause On the process data window, the value for the feedrate is
missing or set to 0.
Action On the process data window corresponding to this alarm,
enter a correct value for the feedrate.
3005
Reference II.4 Guidance Cutting Operations, II.5 Single Cutting
Operations III Types of Cycle Motions
Cause On the process data window, the value for the depth of cut
is missing or set to 0.
Action On the process data window corresponding to this alarm,
enter a correct value for the depth of cut.
3006
Reference III Types of Cycle Motions