
B-63344EN/02 APPENDIX A.PARAMETERS
- 285 -
9850 DRLDEC
DRLDEC Default value of the reduced depth of cut in peck or high-speed peck
drilling (radius) to be set automatically.
Valid data range : 0 to 99,999,999
Units : 0.001mm
0.0001inch
9851 DRLRET
DRLRET Default value of the return clearance for peck or high-speed peck
drilling (radius) to be set automatically.
Valid data range : 0 to 99,999,999
Units : 0.001mm
0.0001inch
9852 DRLMIN
DRLMIN Default value of the minimum depth of cut for peck or high-speed
peck drilling (radius) to be set automatically.
Valid data range : 0 to 99,999,999
Units : 0.001mm
0.0001inch
9853 DRILCF
DRILCF Coefficient for the depth of cut in peck or high-speed peck drilling
(radius) to be set automatically.
Valid data range : 0 to 3000
Units : 1%
The system automatically sets the cutting depth from the following
formula.
Drilling depth of cut = drilling diameter x DRILCF /100
9855 GRDLCL
GRDLCL Clearance (radius) from each start point in C-axis drilling and
grooving
Valid data range : 0 to 99,999,999
Units : 0.001mm
0.0001inch
Cutting
start point
GRDLCL
Drilling or grooving start point
Drilling or grooving start point