
B-63344EN/02 SUPPLEMENT 3.USEFUL FUNCTIONS FOR MACHINING PROCESSES
- 201 -
(12) C-axis reverse tapping by rigid tapping, uneven spacing
:
M(Milling axis stop command P9876);
(M8/M9);
G97G98G40T_ ;
G80;
(Movement to the cutting start point)
M(Milling reverse tapping pre-command P9089);
S_ M(Rigid tapping mode command P5210);
G98(G84/G88)_ ;
G80M(Milling axis stop command P9876);
(Second figure specification)
M(Milling reverse tapping pre-command P9089);
S_ M(Rigid tapping mode command P5210);
G98(G84/G88)_ ;
G80M(Milling axis stop command P9876);
:
(nth figure specification)
M(Milling reverse tapping pre-command P9089);
S_ M(Rigid tapping mode command P5210);
G98(G84/G88)_ ;
G80M(Milling axis stop command P9876);
:
NOTE
When bit 4 (TTM) of parameter No. 9846 is set to 0
or when the bit is set to 0 and parameter No. 9089
is not set, reverse rotation may be specified as the
direction of rotation for tapping. In this case, P/S
alarm, "3008 A WRONG TOOL SELECTED," is
issued.
If the reverse spindle rotation tapping pre-command is used to reverse
the specified direction of spindle rotation, the icon indicating the
spindle rotation status points opposite to the actual direction of
spindle rotation. For this reason, to make the icon points the correct
direction, set the parameter for "using an external signal to display the
spindle rotation status (bit 7 (SPE) of parameter No. 9845)" to 1. Also
set forward and reverse spindle rotation signals for external signal
R987 as follows. The MANUAL GUIDE checks these signals and
display the icon indicating the spindle rotation status.
Bit 0 of R987 = 1: Set to 1 when M03 (forward rotation) is specified.
Bit 1 of R987 = 1: Set to 1 when M03 (reverse rotation) is specified.
When both signals are set to 0, the spindle is assumed to stop.