
A.PARAMETERS APPENDIX B-63344EN/02
- 286 -
9856 TAPCCL
TAPCCL Clearance (radius) from each start point in C-axis tapping
Valid data range : 0 to 99,999,999
Units : 0.001mm
0.0001inch
9858 BRSHFT
BRSHFT Default value of the amount of shift for returning in boring (radius)
Valid data range : 0 to 99,999,999
Units : 0.001mm
0.0001inch
BRSHFT
Return feedrate = F x RMBROV /10
9858 RMBROV
RMBROV Feedrate override for returning in reaming or boring
Return F = F x RMBROV / 10
The tool always returns at return F in reaming.
In boring by turning, the tool normally returns at the rapid traverse
rate. If the hole diameter is small and the clearance is insufficient (the
amount of shift for returning < BRCLER), the tool returns at return F.
Valid data range : 0 to 20
Units : 10%
9861 CRVMCD
CRVMCD M code for rotating the milling axis in the reverse direction in C-axis
tapping
<Related parameters : No.9779#0bit(CRF),No.9779#1bit(CRC)>
Valid data range : 0 to 999