
B-63344EN/02 APPENDIX A.PARAMETERS
- 261 -
TRD 1 : The soft-key for selecting threading is disabled.
0 : The above soft-key is enabled.
GRV 1 : The soft-key for selecting normal grooving is disabled.
0 : The above soft-key is enabled.
TGR 1 : The soft-key for selecting trapezoidal grooving (roughing) is
disabled.
0 : The above soft-key is enabled.
TGF 1 : The soft-key for selecting trapezoidal grooving (finishing) is
disabled.
0 : The above soft-key is enabled.
CNT 1 : The soft-key for selecting center drilling is disabled.
0 : The above soft-key is enabled.
DRL 1 : The soft-key for selecting drilling is disabled.
0 : The above soft-key is enabled.
#7 #6 #5 #4 #3 #2 #1 #0
9764 SNC ANG G1W INC ZOM TAP BOR REM
REM 1 : The soft-key for selecting reaming is disabled.
0 : The above soft-key is enabled.
BOR 1 : The soft-key for selecting boring is disabled.
0 : The above soft-key is enabled.
TAP 1 : The soft-key for selecting tapping is disabled.
0 : The above soft-key is enabled.
ZOM 1 : The soft-key for scaling animation is displayed on page 1.
0 : The soft-key for scaling animation is displayed on page 2.
INC 1 : Incremental values can be input as figure data in single
machining, bar machining, threading, and grooving.
0 : The above function is disabled.
G1W 1 : In grooving, a groove is cut in the same Z direction (from Z+ to
Z-).
0 : In grooving, the center of a groove is first cut and the tool is
moved right and left to cut the groove.
ANG 1 : The angle of a line is input, assuming the clockwise direction as
the negative direction.
0 : The angle of a line is input, assuming the clockwise direction as
the positive direction.
SNC 1 : In semifinishing for bar machining, tool-nose geometric
compensation is applied. It may take time until the tool starts
cutting after it moves to the cutting start point depending on the
specified number of figures.
0 : In semifinishing for bar machining, tool-nose geometric
compensation is not applied.
SNC>=1
<SNC>=0