
B-63924EN/01 2.STANDARD OPERATION
- 107 -
2.3.7.1 Executing a subprogram call operation
A DNC subprogram call operation can be performed as described
below.
Procedure
1 Prepare NC programs for subprogram call operation on the hard
disk of the personal computer.
2 (See Subsection 2.3.7.2, "NC program for subprogram call
operation".)
3 On the [DNC Sub Program Call Setting] screen, select the folder
storing NC programs to be used for a subprogram call operation.
(See Subsection 2.3.7.3, "Specifying a folder storing
subprograms".)
NOTE
Before starting the machine, be sure to check on
the [DNC Sub Program Call Setting] screen that
information about the subprograms to be called
from the main program is displayed.
4 Start the machine.
Afterward, the state of "DNC operation in progress" is set until
the state is reset by the CNC.
<1> Set the MEMORY mode.
<2> Set bit 5 (DNCI signal) of the G43 signal to 0.
<3> Initiate a cycle start.
NOTE
The method of starting a subprogram call operation
varies from one machine to another. For details,
refer to the operator's manual of the machine in
use.
5 On the [DNC Operation Monitor] screen, monitor the progress of
execution. (See Subsection 2.3.8, "Monitoring the Execution
Progress of DNC Operation".)