
B-63924EN/01 2.STANDARD OPERATION
- 125 -
2.4.3.4 Entering a counter value for tool offset data
A coordinate value displayed on the [Relative] screen can be set for
tool offset data.
Procedure
1 If the [Tool Offset] screen is currently not displayed, display the
[Tool Offset] screen as described in Subsection 2.4.3, "Setting
Tool Offset".
2 Press the display/operation switching key
to display the
operation keys.
3 Select tool offset data to be set.
4 Press the operation key
to display the [Tool Offset -
C.Input] screen.
5 Select an axis for a relative coordinate value to be set, then click
the <OK> button. The value of the selected tool offset data is
set.
NOTE
When the lathe system is used, the relative
coordinate value on an axis selected on the [Tool
Offset - C.Input] screen is set as the tool offset
data at the cursor position.
If a relative coordinate value is entered as a
geometry offset value when the machining center
system is used, the following is set:
Geometry offset value = Relative coordinate
value
Wear offset value = 0
If a relative coordinate value is entered as a wear
offset value when the machining center system is
used, the following is set:
Geometry offset value = No change
Wear offset value = Relative coordinate value -
Geometry offset value