
7.THREE-DIMENSIONAL MACHINING SYSTEM LASER FUNCTION B-64663EN/01
- 114 -
Nozzle head fixing mode
When the command specifying the α or β axis is issued, the specified
axis is rotated at the same time linear axes X, Y, and Z are moved.
This allows the specified axis to rotate around the nozzle head
position.
When the α or β axis is rotated by the command, the position of the
nozzle head is changed. The X, Y, and X axes are then moved
according to changed coordinates (X, Y, Z) to return the nozzle head
to the original position.
This operation does not affect the incremental coordinate system and
workpiece coordinate system of the X, Y, and Z axes, but affects their
machine coordinate system.
Setting the maximum speed for the α and β axes
When a command causes the nozzle to perform a large rotational
movement about the α or β axis, while movement along the X-, Y-
and Z-axes is small, the rotation speed may exceed the limit. In such a
case, when the maximum speed for the α and β axes is set in
parameters Nos. 15612 and 15613, the nozzle is moved along the X-,
Y-, and Z- axes at a lower speed that is calculated according to the set
maximum speed (automatic deceleration).
Feedrate clamp function
If the fourth and fifth axes are specified together with the X, Y, and Z
axes, the speeds on the X, Y, and Z axes that have been compensated
for by attitude control B may be very high. This function is intended
to clamp the specified feedrate so that the speeds on the X, Y, and Z
axes that have been compensated for do not exceed the rapid traverse
rate (parameter No. 1420). This function is effective to the G01, G02,
G03, and G12 commands, as well as the interpolation-type G00
command.
The clamp speed in the "G91 G01 Xx Yy Zz Aa Bb Ff" block is
determined as described below.