
B-64663EN/01 LASER FUNCTION 8.CONTROL FUNCTION
- 225 -
Name Function
Program restart (laser
specifications)
×
Others ○: Specifiable ×: Not specifiable
Name Function
Cycle start / feed hold
○
Dry run
○
Single block
○
Interlock
○
Machine lock
○ If the machine lock signals for the
individual axes (MLK1 to MLK8) are
turned on/off, no
acceleration/deceleration is applied
to the axes for which the machine
lock has been applied.
Control in/control out command ( )
○
Optional block skip command (/n:n
is a number)
○
Auxiliary function (Mxxxx)
○ Only function code signals and
function strobe signals are output.
Tool function (Txxxx)
○ Only function code signals and
function strobe signals are output.
Second auxiliary function (Bxxxx)
○ Only function code signals and
function strobe signals are output.
Simple synchronous control
○ It is not possible to switch between
synchronization and no
synchronization.
Program restart
×
Retrace function
×
Macro executor (execution macro)
×
MDI operation
× If G05.1Q1 is specified in MDI mode,
P/S alarm No. 5113 is raised. In AI
contour control mode, it is not
possible to perform operation by
switching to MDI mode.
Manual intervention
× If manual intervention is performed, it
is necessary to return the
coordinates to the position of
intervention at a restart. Otherwise,
P/S alarm No. 514 is raised.
* Look-ahead of multiple blocks is not performed.
Conditions for entering AI contour control mode
To specify G05.1Q1, the modal must be as given below. If these
conditions are not satisfied, P/S alarm No. 5111 is raised.
G code Meaning
G00 Positioning
G01 Linear interpolation
G02 Circular interpolation (CW)
G03 Circular interpolation (CCW)