
2.FUNCTIONS DIFFERING FROM THE M SERIES SPECIFICATIONS LASER FUNCTION B-64663EN/01
- 42 -
2.4 PROGRAM RESTART (LASER SPECIFICATIONS)
Overview
If machining is stopped during automatic operation, machining can be
resumed from a specified block.
Signal
- Program restart signal
REST2<G226#1>
[Classification] Input signal
[Function] This signal selects program restart (laser specifications).
[Operation] <1> Select EDIT mode, and display the program. Position the cursor
to the block from which you want to restart the program.
<2> Select memory mode, set the program restart signal (REST2) to 1,
and perform cycle start. Then, search starts, and the automatic
operation started signal (STL) and the proximity point search in
progress signal (LNSR) are set to
<3> During search, M codes and other auxiliary functions are all sent
to the PMC. Every time such a auxiliary function code is sent,
the completion signal (FIN) should be returned.
<4> During search, dwell commands are not executed.
<5> During search, laser output is not performed.
<6> When a block immediately before a specified block is found,
positioning to the end point of that block is performed, after
which the search operation terminates.
<7> Upon the completion of the search, the feed hold state is entered,
and the automatic operation started signal (STL) is set to 0.
<8> Check that the proximity point search in progress signal (LNSR)
is 1, and that the automatic operation started signal (STL) is 0 on
the PMC side. Then, set the program restart signal (REST2) to 0.
<9> Set the automatic operation start signal (ST) to 1 then to 0. Then,
automatic operation restarts from the specified block.