
7.THREE-DIMENSIONAL MACHINING SYSTEM LASER FUNCTION B-64663EN/01
- 152 -
Switching between W-axis tracing and Z-axis tracing
When the W-axis tracing option is attached, the tracing axis is the
W-axis. If both the W-axis tracing and Z-axis tracing options are
attached, it is possible to switch the tracing axis between W- and
Z-axes.
Commands
(1) If a G code is used
W-axis tracing
G13 (L0);
Z-axis tracing
G13L2;
(2) If an external signal is used
W-axis tracing
G225#0:ZTRM=0
Z-axis tracing
G225#0:ZTRM=1
NOTE
Before switching the tracing axis, cancel tracing
control.
Parameter
1420 Rapid traverse rate for the axis
1424 Manual rapid traverse rate for the axis
[Data type] 2-word axis
[Unit of data]
Valid data range
[Valid data range]
Increment
system
Unit of data
IS-A, IS-B IS-C
Metric machine 1mm/min 30 to 240000 30 to 100000
Inch machine 0.1 inch/min 30 to 96000 30 to 48000
The rapid traverse rate for the W-axis (sixth axis) is specified on the
sixth axis.
1836 Minimum position error at a W-axis reference position return
[Data type] Byte axis
[Unit of data] Detection unit
[Valid data range] 0 to 127
If 0 is specified, 128 is assumed.
[Guideline of setting] Highest value with which no alarm occurs at a reference position
return