
B-64663EN/01 LASER FUNCTION 8.CONTROL FUNCTION
- 193 -
Tracing control
The standard shift used for piercing specified by the E code continues
to be effective during execution of the start-up function. When a
start-up is completed (the return distance has been moved through),
the standard shift for cutting is selected.
If piercing is not based on the E code, the currently effective standard
shift continues to be effective for the start-up function.
Single-block stop and dry run
The start-up function does not work for single-block stop and dry run.
Sample program
The following sample program uses the start-up function.
1 The nozzle is positioned at a point (X50, Y50). At this point, the
G32 assist gas and G24 piercing commands are executed in the
stated sequence.
2 When piercing is completed, the cutting assist gas is selected,
and machining begins.
3 A start-up operation is performed in interval A (specified return
distance), where machining is carried out using the feedrate,
output peak value, frequency, and duty cycle specified for a
return operation.
4 When the start-up operation ends, machining continues using the
programmed feedrate, output peak value, frequency, and duty
cycle.
Parameter
For information on the specifiable parameters, see the section on edge
machining.