
B-64663EN/01 LASER FUNCTION 5.LASER OUTPUT CONTROL
- 71 -
To execute a machining program without outputting the laser beam,
set both the beam lock signal (*BEMLC) and shutter lock signal
(*SHTLC) to 0. This setting can also be used to operate the machine
while the oscillator is not connected or not adjusted, or to check a
machining program (movements only).
When the beam on state is selected, the beam output signal (BEAM) is
set to 1. The PMC can check this state.
Signal
- Beam on signal
BEMON<G222#4>
[Classification] Input signal
[Function] The beam can be turned on and off by an external signal.
[Operation] When the oscillator is in the oscillation state (oscillation signal LSTR
is set to 1), while when the shutter is opened, the external signal turns
the beam on or off.
(1) When bit 6 (LHC) of parameter No.15001 is set to 0
The beam is output by setting the beam on signal (BEMON) to 1
in manual operation mode.
(2) When bit 6 (LHC) of parameter No.15001 is set to 1
The beam is output by setting the beam on signal (BEMON) to 1
in automatic or manual operation mode.
Instead of the G code, an M code can be used to turn the beam on
or off.
This method controls the beam through the PMC, causing a delay
relative to beam control with the G code.
- Beam lock signal
*BEMLC<G222#1>
[Classification] Input signal
[Function] This external signal can interlock the beam on command. The signal
can be used for safety check or for automatic operation in which the
motion of the machine is checked without activating or connecting the
oscillator.
[Operation] When the beam lock signal (*BEMLC) is set to 0, the CNC enters the
beam lock state. In this state, the beam on command (G32 or beam on
signal (BEMON)) cannot be used to output the beam.
To output the beam, set the beam lock signal (*BEMLC) to 1.
0: Beam lock state
1: Beam lock released
- Beam output signal
BEAM<F221#7>
[Classification] Output signal
[Function] Notifies the PMC that the beam is output.
[Output condition] The signal is set to 1 when:
- The beam is turned on.
The signal is set to 0 when:
- The beam is turned off.