
B-64663EN/01 LASER FUNCTION 8.CONTROL FUNCTION
- 237 -
#7 #6 #5 #4 #3 #2 #1 #0
1603 RBL
[Data type] Bit
RBL In AI contour control mode, rapid traverse acceleration/deceleration
is:
0: Linear acceleration/deceleration.
1: Bell-shaped acceleration/deceleration.
1621
Rapid traverse bell-shaped acceleration/deceleration time constant for each
axis
[Data type] Word axis
[Unit of data] 1 msec
[Valid data range] 0 to 512
Specify tb, shown in the figure below, for each axis. If the setting is 0,
linear acceleration/deceleration is assumed.
Speed
Time
tb tb
ta
tb tb
ta
Linear acceleration/deceleration
Bell-shaped acceleration/deceleration
ta: Depends on the linear acceleration.
tb: Bell-shaped time constant
7061 Number of block overlaps
[Data type] Byte
[Unit of data] Blocks
[Valid data range] 0 to 40
To overlap multiple blocks, specify the maximum number of block
overlaps. If the setting is 0, 5 fives are assumed.
#7 #6 #5 #4 #3 #2 #1 #0
7050 MI1 MI0
[Data type] Bit
MI1、MI0 Set the following values:
MI1 MI0
Setting 0 1