
7.THREE-DIMENSIONAL MACHINING SYSTEM LASER FUNCTION B-64663EN/01
- 156 -
7.6 PROXIMITY POINT SEARCH FUNCTION
Overview
This function can search for the start point of a block located within
the constant distance specified in the appropriate parameter from the
current nozzle position, and position the tool at that position so that
machining can restart at that position.
Operation
After the program is set and the memory operation mode is selected,
triggering a cycle start with the proximity point search signal
(NRSRH) set to "1" causes a search through the program for a block
with the following condition. The search begins at the first block.
When this search starts, the proximity point search in progress signal
(LNSR) and automatic operation started signal (STL) are set to "1".
When a block with the following conditions is found, the nozzle is
positioned at the beginning of this block. After nozzle positioning is
completed, the machine stops, and the automatic operation started
signal (STL) is reset to "0". Under this condition, resetting the
proximity point search signal (NRSRH) to "0" and triggering a cycle
start will reset the LNSR signal and cause machining to begin at the
block found.
Conditions for a block to be searched for
(1) Distance Ls from the start point (Xs, Ys, Zs) of a block to the
current nozzle position (Xp, Yp, Zp) is smaller than distance L
specified in parameter No. 15635.
(2) Distance Le from the end point (Xe, Ye, Ze) of a block to the
current nozzle position (Xp, Yp, Zp) is larger than distance Ls.