
2. FUNCTION SPECIFICATIONS THAT DIFFER
FROM THE M series
B–63683EN/01
20
If the SBK signal is set to 1 while a pattern such as a bolt hole circle (G26)
is being specified, the operation does not stop at the end of each program
block. It stops only after the tool has been positioned to each punch point
and punching completed. In this case, feed hold signal SPL is set to 1
when the cycle start lamp signal STL is set to 0, posting notification that
it is not the end of a single block of the program. Once the operation of
one block has been completed, both the STL and SPL signals are set to
0 and the operation stops.
If the SBK signal is set to 1 during nibbling or automatic repositioning,
a stop is made upon the completion of a series of actions.
2.4.3
Single Block
Difference