
B–63683EN/01
2. FUNCTION SPECIFICATIONS THAT DIFFER
FROM THE M series
21
In G00 mode, punching is executed after the completion of axial
movements.
Generally, the F command cannot be specified in G00 mode. The F
command can be specified only when the G0F bit (bit 0 of parameter
16050) is set accordingly.
For T– or C–axis command blocks, nonlinear interpolation positioning
is performed, even if linear interpolation positioning is specified.
#7
16050
#6 #5 #4 #3 #2 #1 #0
G0F
[Data type] Bit
G0F For a rapid traverse command (G00), the X–axis or Y–axis rapid traverse
feedrate is set to the value:
0 : Specified in the parameter.
1 : Specified by the F code.
NOTE
1 If no F command is detected, alarm 011 occurs.
2 If the speed specified with the F command exceeds that set
in parameter 1420, the specified speed is reduced to that
specified in the parameter.
3 In nibbling mode, pitch movement is performed at the speed
specified in parameter 1420.
4 The programmable rapid traverse override function cannot
be used.
2.5
INTERPOLATION
FUNCTION
2.5.1
Positioning
Difference
Parameter