4. DESCRIPTION OF PARAMETERS
B–63010EN/02
154
OSR In programming number search, when pressing soft key [O–SEARCH]
without inputting program number by key :
0 : Search the following program number
1 : Operation is invalid
NE9 Editing of subprograms with program numbers 9000 to 9999
0 : Not inhibited
1 : Inhibited
The following program editing during operation is invalid.
(1) Program deletion (Even when deletion of all programs is specified,
programs with program numbers 9000 to 9999 are not deleted.)
(2) Program punching (Even when punching of all programs is specified,
programs with program numbers 9000 to 9999 are not punched.)
(3) Program number search
(4) Program editing after registration
(5) Program registration
(6) Program collation
(7) Displaying programs
CPD When an NC program is deleted, a confirmation message and
confirmation soft key are:
0 : Not output.
1 : Output.
PSR Search for the program number of a protected program
0 : Disabled
1 : Enabled
NOTE
If this parameter is set, a protected program is also
displayed.
#7
MCL
3203
#6
MER
MER
#5
MZE
MZE
#4
PIO
#3 #2 #1 #0
MCL
[Data type] Bit
PIO When two–path control is controlled, program input/output is:
0 : Controlled separately for each tool post.
1 : Controlled on a two–path control basis for path 1 and path 2.
MZE After MDI operation is started, program editing during operation is:
0 : Enabled
1 : Disabled
MER When the last block of a program has been executed at single block
operation in the MDI mode, the executed block is:
0 : Not deleted
1 : Deleted