4. DESCRIPTION OF PARAMETERS
B–63010EN/02
402
7773
Number of position detector pulses per rotation about workpiece axis
[Data type] 2–word
[Data unit] Detection unit
[Valid data range] 1 to 99999999
This parameter specifies the number of pulses per rotation about the
workpiece axis (on the fourth axis side), for the position detector.
The number of feedback pulses for the position detector is 360000 for a
rotation axis for which the detection unit is 0.001 deg.
7776
Feedrate during automatic phase synchronization for the workpiece axis by the
automatic EGB phase synchronization function
[Data type] 2–word
[Unit of data, Valid data range]
Valid data range
Increment system Unit of data
IS–B IS–C
Rotation axis 1 deg/min 30 to 240000 6 to 100000
This parameter sets the feedrate during automatic phase synchronization
for the workpiece axis by the automatic EGB phase synchronization
function.
Angle shifted from the spindle position (one–rotation signal position) the workpiece
axis uses as the reference of phase synchronization by the automatic EGB phase
synchronization function
7777
[Data type] 2–word
[Unit of data]
Increment system IS–B IS–C Unit
Rotation axis 0.001 0.0001 deg
[Valid data range] 0 to 3600000
This parameter sets the angle shifted from the spindle position
(one–rotation signal position) the workpiece axis uses as the reference of
phase synchronization by the automatic EGB phase synchronization
function.
[Example]