
7. CHECKING MACHINING PROGRAMS
B–63284EN/03
OPERATION
94
NOTE
1 During C/Y–axis machining, interference checks are not
performed.
2 In animated simulation for the NC statement after NC
statement conversion, interference checks are not
performed.
3 When a warning message appears, pressing the [EXEC]
soft key clears the warning status.
4 The speed and other conditions for actual machining are
different from those for simulation. Therefore, interference
between tools may not be checked correctly.
5 When this function is enabled, the automatically set figures
of some tools are changed, as shown below.
– Center drilling tool
⇒
This function: Disabled Enabled
– Drilling tool
⇒
This function: Disabled Enabled
– Tapping, reaming, and end mill tools (for turning)
⇒
This function: Disabled Enabled