
13. SETTING DATA
B–63284EN/03
OPERATION
188
: Radius of a tool tip
When bit 0 (TLC) of parameter 9774 is set to 1,
the tool tip radius in a conversationally coded
program is specified separately from that in an
NC–format program, and the former values
copied to the NC offset data when the program
is executed.
When the bit is set to 0, the same tool tip radius
is used in both a conversationally coded program
and an NC–format program.
: See the following figures.
: See the following figures.
(1) Outer surface (right hand) (2) Outer surface (left hand)
AC
AN
AN
AC
AN
(3) Inner surface (right hand) (4) Inner surface (left hand)
AC
AN
AC
(5) End face (negative direction) (6) End face and inner bottom face (posi-
tive direction)
AC
AN
AC
AN
NOTE
When a button tool is used, the cutting edge angle and tool
angle are not displayed.
: Need to be set only when the figure of a tool to
be drawn is determined.
NOSE–RADIS
(RN)
CUTTING EDG (AC)
NOSE–ANGLE (AN)
NOSE WIDTH
(TW)