
B–63284EN/03
1. MACHINING PROGRAMS FOR
2–AXES (X AND Z–AXIS) LATHES
TYPES OF MACHINING
PROGRAMS
291
(1) Generals
When tool whose cutting edge angle is acute is used in bar and
pattern repeating processing , it is possible machining that tool and
material don’t interfere.
Parameter non–setting Parameter setting
#7
9767
#6 #5 #4 #3 #2 #1
SGT
#0Bit No.
SGT 0 : Usual machining
1 : It is possible machining which give consideration to cutting edge
angle. And it is possible to input the tool cutting edge data with
decimal value in tool data screen.
Compensation of conditions are following. (And above–mentioned
parameter set to 1. )
(a) Interference The tool and material interfere in
usual machining.
(b) Cutting edge angle The cutting angle of the tool is less than
90 degrees. (When round nose tool is
used, this compensation
becomes ineffective.)
(c) Figure The product figure will be limited to
monotonous increase in the
direction of the X–axis and Z–axis.
End point Start point End point
ineffective ineffective
Start point
1.1.11
Compensation by Tool
Cutting Edge Angle