
A. PARAMETERS
B–63284EN/03
APPENDIX
704
#7
WDM9767
#6
NT0
#5
SFG
#4
MTA
#3
NCR
#2
PAP
#1
SGT
#0
SFC
SFC 1 : For arcs created in bar material machining by pattern repeating, arc
radius compensation is applied using both tool–tip radius and
finishing allowance.
0 : The compensation stated above uses only the tool–tip radius; the
finishing allowance is used as a shift amount for compensation.
SGT 1 : Compensation based on the cutting edge angle is enabled.
0 : Compensation based on the cutting edge angle is disabled.
PAP 1 : In machining by pattern repeating, the X– and Z–axes move to the
beginning of the shape, one at a time.
0 : In machining by pattern repeating, the X– and Z–axes move to the
beginning of the shape simultaneously.
NCR 1 : G41 or G42 is not used in the finishing phase of bar machining and
pattern repeating.
0 : G41 and G42 are used in the finishing phase of bar machining and
pattern repeating.
MTA 1 : Multiple threading is carried out by specifying an angle (address Q).
0 : Multiple threading is carried out by shifting the beginning of the start
point of each thread.
SFG 1 : Bar material machining for contours containing very small steps is
enabled.
0 : Bar material machining for contours containing very small steps is
disabled.
NT0 1 : An offset cancel command in a conversational program is issued
using T**00 (where ** is the tool selection number).
0 : An offset cancel command in a conversational program is issued
using T0.
WDM 1 : The X–coordinate of a cut–in start point in machining the inner
surface is calculated from the blank inner surface machining process
or a drilling process.
0 : The X–coordinate of a cut–in start point in machining the inner
surface is calculated from the minimum X–coordinate of the contour
in machining the inner surface.
#7
NRA9768
#6 #5
NDO
#4
SWC
#3
SCC
#2
SSC
#1
NBC
#0
SBC
SBC 1 : Characters in the title bar of the contour data input window are
displayed in black.
0 : Characters in the title bar of the contour data input window are
displayed in white.
NBC 1 : Characters in the title bar of the guidance window are displayed in
black.
0 : Characters in the title bar of the guidance window are displayed in
white.