
1. MACHINING PROGRAMS FOR
2–AXES (X AND Z–AXIS) LATHES
B–63284EN/03
TYPES OF MACHINING
PROGRAMS
384
The single action process executes a simple move command or auxiliary
function block.
When the cursor is moved to the end of the program, a new process is
created automatically, and a machining type menu is displayed in the soft
key field.
Pressing one of the [SINGL] soft key selects the single–action process.
TOOL–NO : Tool management number of a tool to be used
for a single action
T–CODE : T–code for tool selection
FEED RATE : Select the desired type of FEEDRATE from the
following menu items.
0 = mm/rev
1 = mm/minute
CUT–SPD (m/minute): Cutting speed (constant surface speed control
enabled)
Pressing the [SPINDL SPEED] soft key
enables the direct specification of the spindle
speed. Constant surface speed control,
however, is disabled.
NOTE
Single action is not supported by the detail data screen. The
profile of a workpiece cannot be drawn on this screen.
Seven types of single actions can be specified.
One single action process allows up to 30 blocks to be registered.
(1) AUX–F
M: M–code
S : SPINDLE SPD.
(2) POSITN (G00)
X : END POS. X
Z : END POS. Z
1.9
SINGLE ACTION
1.9.1
Machining Type
Selection
1.9.2
Details of Process Data
1.9.3
Details of Figure Data