
B–63284EN/03
4. CONVERTING A MACHINE PROGRAM
IN THE RIGHT–HAND COORDINATE
SYSTEM TO THAT IN THE LEFT–
HAND COORDINATE SYSTEM
TYPES OF MACHINING
PROGRAMS
479
A machining program created in the conversational mode is converted to
an NC–format program through the conversion operations described
below.
(1) Axis command along the X–axis
The signs of all axis commands along the X–axis are reversed.
(2) G–codes
All G–codes associated with the coordinate planes in a machining
program are converted as follows:
G02 →G03
G03 →G02
G41 →G42
G42 →G41
(3) G–code commands for animated simulation
Graphic commands starting with G10 P9
****
for animated
simulation are always deleted in conversion to an NC format
program.
NOTE
NC–format programs after conversion cannot perform
animated simulation.
4.2
DETAILS OF
CONVERSION TO
MACHINING
PROGRAM IN THE
LEFT–HAND
COORDINATE
SYSTEM
4.2.1
Conversion of
Machining Programs