
1. CREATING MACHINING
PROGRAMS FOR TWO–PATH
4–AXIS(X1, Z1, X2, AND Z2) LATHES
B–63284EN/03
EXAMPLES OF CREATING
PROGRAMS
496
(1) Registering a right–hand outside surface cutting tool (HEAD–L)
On the screen with a registered–tool directory displayed, press:
[TOOL ENTRY]
After making sure the tool data is displayed on the screen, specify:
[GENERAL OUTTER] (Tool type)
[HEAD–L] (Tool post)
[ ] (Direction of the tool)
[COMMON] (Roughing or finishing)
0101 INPUT (T–code)
[NORMAL] (Direction of rotation)
0.4 INPUT (Tool tip radius)
90 INPUT (Cutting edge angle)
60 INPUT (Tool angle)
20 INPUT (Tool width)
3 INPUT (Direction of imaginary tool nose)
[CARBID] (Tool material)
NOTE
Pressing the [TOOL LIST] soft key redisplays the
registered–tool directory.
(2) Registering a left–hand outside surface cutting tool (HEAD–R)
On the screen with a registered–tool directory displayed, press:
[TOOL ENTRY]
After making sure the tool data is displayed on the screen, specify:
[GENERAL OUTTER] (Tool type)
[HEAD–R] (Tool post)
[ ] (Direction of the tool)
[COMMON] (Roughing or finishing)
1111 INPUT (T–code)
[NORMAL] (Direction of rotation)
0.4 INPUT (Tool tip radius)
90 INPUT (Cutting edge angle)
60 INPUT (Tool angle)
20 INPUT (Tool width)
3 INPUT (Direction of imaginary tool nose)
[CARBID] (Tool material)
1.2
SETTING TOOL DATA
AND CUTTING
CONDITION DATA
1.2.1
Setting Tool Data