
B–63284EN/03
3. CREATING MACHINING
PROGRAMS FOR LATHES
WITH THE C–AXIS
EXAMPLES OF CREATING
PROGRAMS
533
(2) Entering contour data (notching around the C–axis)
Pressing the cursor–down key (↓) at the end of the operations (1)
displays an entry window for contour approach data. Enter the
contour data according to the design drawings.
80 INPUT (Machining start point X–coordinate)
0 INPUT (Machining start point C–coordinate)
[ ] (Direction of approach)
30 INPUT (Radius of approach)
[INSERT]
[ ° ]
[INSERT]
[ + ]
[ ] (Direction of movement)
0 INPUT (Taper line end point X–coordinate)
40 INPUT (Taper line end point C–coordinate)
INPUT
30 INPUT (Angle)
[INSERT]
[ + ]
[ ] (Figure pattern)
After placing the cursor on the angle (K/J), specify:
30 INPUT (Angle)
[INSERT]
[ ↓ ] (Figure pattern)
INPUT
–80 INPUT (End point X–coordinate)
[ + ]
[ ] (Figure pattern)
0 INPUT (Taper line end point X–coordinate)
–40 INPUT (Taper line end point C–coordinate)
INPUT
30 INPUT (Angle)
[ + ]
[ ] (Figure pattern)
After placing the cursor on the angle (K/J=), specify:
30 INPUT (Angle)
[INSERT]
[ + ]
[ START ] (Figure pattern)
[ + ]
[ESCAPE] (Figure pattern)
30 INPUT (Clearnce radius)
[INSERT]
¿
½
¼
¾