
4. TYPES OF SCREENS
B–63284EN/03
OPERATION
30
(9) Figure data programming screen
Dimension data required for machining is entered and displayed on this
screen. All processes excepting the end facing processes, consist of the
process data explained previously and the figure data.
The maximum number of figure data items that can be included in each
machining process is given below:
(a) Bar machining: 30
(b) Pattern repeating: 30
(c) Residual machining: 5
(d) End facing: No figure data is needed.
(e) Threading: 5 (for general–purpose threads and metric threads)
(f) Grooving: 1
(g) Necking: 5
(h) Center drilling: 1
(i) Drilling: 1
(j) Tapping: 1
(k) Single action: 30 (Single action II: 104)
(l) M code: 5
(m) C–axis center drilling/drilling/reaming/tapping:
6 (for uneven intervals), even intervals can be specified.
(n) C–axis grooving: 6 (for uneven intervals), even intervals can be
specified.
(o) C–axis notching: 30
(p) C–axis cylindrical machining: 30
(q) C–axis milling: 30
(r) Y–axis center drilling/drilling/reaming/tapping: 6 (for uneven
intervals), A hole pattern can be specified.
(s) Y–axis milling: 30
Arbitrary figures formed by arcs and lines can be specified for bar
machining, pattern repeating, C–axis notching, C–axis cylindrical
machining, C–axis milling, and Y–axis milling machining. These
arbitrary figures are called contour figures.
By entering dimensional data specified on a drawing, intersections at the
corners of the contour figure can be automatically calculated and the
results are displayed.