
B–63284EN/03
2. MACHINING PROGRAMS FOR
LATHES WITH C–AXIS
TYPES OF MACHINING
PROGRAMS
445
(Development drawing)
C
Side–face end mill
X
Z
C
Z
To enable this machining, set the following parameter:
#7
CML9764
#6 #5 #4 #3 #2 #1 #0
CML 1 : Enables C–axis milling.
0 : Disables the above function.
NOTE
When this function is enabled, C–axis cylindrical machining
cannot be selected.
Along the contour specified in the figure data, C–axis side face milling
is performed only once with the side face end mill tool. Input the contour
along which the tool should move. In–feed machining is not performed
in the X direction.
When the cursor is positioned to the end of a program, a new process is
automatically created, and the machining type soft key menu is displayed.
Press [C–MIL] and then [CROSS] to select a C–axis side face milling
process.
2.9
C–AXIS SIDE FACE
MILLING
2.9.1
Selecting the
Machining Type