
B–63284EN/03
A. PARAMETERSAPPENDIX
711
TCD 1 : T–code call is executed instead if T–code output.
0 : T–code call is not executed.
When a conversational machining program is executed, a subprogram
is called from a storage area on the tape or system ROM. The T code is
not output.
<Related parameter: Bit 7 (CLT) of No. 9778>
GTL 1 : The tailstock is not displayed in the initial stage for graphic drawing.
0 : The tailstock is displayed in the initial stage for graphic drawing.
MDL 1 : In the NC statement output, a continuous–state G code (G code of the
01 group) and F code are not output if they are the same as those in the
previous block.
0 : In the NC statement output, a continuous–state G code (G code of the
01 group) and F code are output even if they are the same as those in
the previous block.
NOTE
When the NC statement output function is not provided, set
the corresponding parameters to 0.
TRT 1 : When the tool is first moved to the tool–change position after
machining is started, it travels first along the Z–axis then along the
X–axis.
0 : When the tool is first moved to the tool–change position after
machining is started, it travels first along the X–axis then along the
Z–axis.
After a machining process is completed, the tool always moves to the
tool–change position by traveling first along the X–axis then along
the Z–axis.
#7
AUT9774
#6
GPW
#5
T0O
#4
M1O
#3
28O
#2
MLT
#1
MLS
#0
TLC
TLC 1 : The tool nose radius and virtual tool nose direction of tool data differ
between the conversational data and NC data. When an execution
program is selected, the conversational tool data is written into the
corresponding NC data area according to the information in the
program (T code used).
0 : The conversational program has the same tool tip radius and virtual
tool tip direction as the NC program.
MLS 1 : Stops the milling axis once before the rotation direction of the milling
axis is changed. An M code for stopping the milling axis is specified
by parameter setting.
<Related parameter: No. 9876 (MLSTPM)>
0 : When the direction in which the cutter revolves around the milling
axis is changed, the M code to stop the cutter is not output.
When the milling mode is changed to the turning mode, the M code to stop
the cutter from revolving around the milling axis is output.