
B–63284EN/03
A. PARAMETERSAPPENDIX
719
pass point 2.
Setting range: 0 to 99999999 Increment: 0.001 mm
0.0001 inches
Common safety point (passing
point 2, V2)
INCLRZ
Cutting start point
9784 SFCLRX
SFCLRX: Clearance to the cutting or machining start point along the X–axis
(diameter). A value found from this data is automatically set as an initial
value for the cutting start point and machining start point.
Setting range: 0 to 99999999 Increment: 0.001 mm
0.0001 inches
9785 SFCLRZ
SFCLRZ: Clearance to the cutting or machining start point along the Z–axis. The
cutting or machining start point is automatically determined based on this
data.
Setting range: 0 to 99999999 Increment: 0.001 mm
0.0001 inches
NOTE
The cutting or machining start point is calculated as follows:
1. Bar machining
(1) [Outer surface]:
X = [Maximum outside diameter of the workpiece]
Z = [End face of the workpiece] + [Parameter No. 9785]
(2) [Outer surface + automatic residual machining]:
X = [Maximum outside diameter of the workpiece (or +
[Parameter No. 9784])]
Z = [End face of the workpiece (or + [Parameter No. 9785])]
= [Z coordinate of start point on the contour]
(3) [Inner surface]:
X = [Minimum inside diameter of the workpiece (or [Maximum
diameter of a hole drilled in the workpiece])]