
B–63284EN/03
1. MACHINING PROGRAMS FOR
2–AXES (X AND Z–AXIS) LATHES
TYPES OF MACHINING
PROGRAMS
265
Chamfering
Temporary figure block
Specify the end point of the figure block immediately before the
final figure block, allowing the end point of chamfering or corner R
in the final block to be calculated.
(3) Horizontal line
(a) When the immediately preceding block is pending, and contact
point determination is not specified
i) When the X coordinate of a horizontal line is entered
å The intersection with the immediately preceding figure
block is calculated. However, this figure is pending.
Intersection
X
When the immediately preceding block specifies an arc,
the intersection selection request screen appears. Press
[CROSS 1] or [CROSS 2], then press [INSERT] (or
[ALTER] or [ALTER FIGURE] to change the figure).
ii) When the X coordinate (X) of a horizontal line is entered,
together with the Z coordinate (Z) of an end point, or a line
length (W)
å The intersection with the immediately preceding figure
block is calculated, and the end point is determined.
Intersection
Intersection
(End point of ) (End point of )
(X, Z)
W