
2. MACHINING PROGRAMS FOR
LATHES WITH C–AXIS
B–63284EN/03
TYPES OF MACHINING
PROGRAMS
402
(2) Figure data when UNEQ INTRVL is specified as the hole interval
Up to six end face holes can be specified at arbitrary positions with
arbitrary hole depths.
POINTn X: X–coordinate of the nth hole position
POINTn C: C–coordinate of the nth hole position
STAT–PZ:Z–coordinate of the nth hole start point
NOTE
In drilling, cutting starts at a point which allows for a drilling
clearance (parameter 9855: GRDLCL).
Hole depth
Drilling clearance (parameter
9855: GRDLCL)
Machining start point
Z–coordinate of the hole start point
DEPTH (E): Hole depth at the nth point (to be specified for each
hole)
NOTE
1 Machining is not performed for a hole unless all the figure
data above is entered.
2 Moving the cursor to the next line displays the figure data in
sequence. To specify the second and subsequent points,
enter the coordinates for the figure data. When all the hole
positions have been specified, press the [FIGURE END]
soft key. Hole machining starts at a position distant from the
hole start point by an amount equal to the hole machining
clearance (specified with parameter No. 9855 (GRDLCL)).
As with the drilling operations in turning, an automatic pre–tool selection
function is available for the C–axis end face drilling operations.
2.1.4
Automatic Pre–tool
Selection Function