
Parameter No. 9876
Parameter No. 27106
Parameter No. 5210
Parameter No. 9876
Parameter No. 27106
Parameter No. 5210
Parameter No. 9876
Parameter No. 27106
Parameter No. 5210
Parameter No. 9876
B–63284EN/03
8. IMPROVEMENT OF TAPPING
ADDITIONAL FUNCTIONS OF SERIES
BH0M/BH1D/BH2D, BH1E/BH2E/BH3E,
AND BH1F/BH2F/BH3F
597
(12) C–/Y–axis reverse milling and rigid tapping, UNEQ INTRVL
:
M(Command for stopping milling axis for HD1 or HD2);
(M8/M9);
G97G98G40T–;
G80;
(Move to cutting start point)
M(Command before reverse milling and tapping for HD1 or HD2);
S– M(Rigid tapping mode command for HD1 or HD2);
G98(G84/G88)–;
G80M(Command for stopping milling axis for HD1 or HD2);
(Specification of the 2nd figure)
M(Command before reverse milling and tapping for HD1 or HD2);
S– M(Rigid tapping mode command for HD1 or HD2);
G98(G84/G88)–;
G80M(Command for stopping milling axis for HD1 or HD2);
:
(Specification of the n–th figure)
M(Command before reverse milling and tapping for HD1 or HD2);
S– M(Rigid tapping mode command for HD1 or HD2);
G98(G84/G88)–;
G80M(Command for stopping milling axis for HD1 or HD2);
:
NOTE
If the reverse rotation is specified as the tap rotation
direction in one of the following cases, P/S alarm “3008
WRONG TOOL SELECTED” is displayed:
– Bit 1 (MTM) of parameter No. 27002 is set to 0 or;
– Bit 1 (MTM) of parameter No. 27002 is set to 1, and
parameter No. 27106 is not set.