
1. THREE–PATH COMPLEX
LATHE FUNCTION
B–63284EN/03
ADDITIONAL FUNCTIONS OF SERIES
BH1E/BH2E/BH3E AND BH1F/BH2F/BH3F
631
NOTE
1 You can change spindles only in tool post 1.
2 When the spindle is changed, the area to be machined
remains unchanged. Spindles can be changed only for the
following processes:
– Bar machining (outer surface and residual machining, and
inner surface and residual machining) (when scheduled)
– Pattern repeating (outer middle and inner middle) (when
scheduled)
– Threading
– Grooving (standard and trapezoidal grooves on outer and
inner surfaces)
– Necking (outer and inner surfaces)
To insert a wait process, move the cursor to the position to which you want
to insert the wait process, then press the [INSERT WAIT] soft key.
You can check machining programs in animation mode by using the
following methods:
D Machining simulation
D NC statement conversion
D Drawing during machining by direct operation
NOTE
When Super CAPi T is provided, drawing is disabled during
machining by executing NC statements.
For how to check machining programs by drawing when Super CAPi T
is not installed, refer to the description of the FS16i–TA or FS16i–TB
three–path graphic function.
In conversational mode, machining operation on a three–path complex
lathe can be checked through machining simulation.
D For lathes with tool post 1 (the first path) located on the upper side
which allows main–spindle and sub–spindle machining, tool post 2
(the second path) on the lower side which allows sub–spindle
machining only, and tool post 3 (the third path) on the lower side which
allows main–spindle machining only (when parameter No. 27124 is
set to 0 or 1)
1.2.7
Inserting a Wait
Process
1.2.8
Checking a Machining
Program by Animated
Simulation
1.2.8.1
Machining simulation
Description