
A. PARAMETERS
B–63284EN/03
APPENDIX
700
#7
OIL9763
#6
NWT
#5
BLC
#4 #3
PTF
#2
ATL
#1
NCP
#0
HDS
HDS 1 : Automatically selects a tool post according to the previously input
tool post selection data.
0 : Automatically selects a tool post according to the sequential
relationships between the input and pass processes.
NOTE
If the combined lathe function is enabled (the CPX bit (bit 6
of parameter No. 9764) is set to 1), automatic tool post
determination is performed according to the tool post last
selected. (The state is the same as when the HDS bit (bit
0 of parameter 9763) is set to 1.)
NCP Always set “0.”
ATL 1 : When altering a tool data, the tool figure data is not automatically
rewritten. Only by pressing the soft key [AUTO FIGURE] it is.
0 : When altering a tool data, the tool figure data is automatically
rewritten.
PTF 1 : Enables the tool data protect function during tooling.
0 : Disables the above function.
BLC 1 : Enables balance cutting.
0 : Disables the above function.
NOTE
This parameter can be set when bit 6 (CPX) of parameter
9764 or bit 7 (1SP) of parameter 9771 is set to “1.”
NWT 1 : Makes “waiting” processes available.
0 : Makes “waiting” processes unavailable.
NOTE
This parameter can be set to 1 only when the combined
lathe support function is enabled.
Waiting processes are created by machine tool builders.
For details, refer to manuals provided by the machine tool
builder.
OIL 1 : Enables the function for selecting two types of coolants.
0 : Disables the above function.
#7
CML9764
#6
CPX
#5
SP2
#4 #3 #2
TOT
#1
UPC
#0
TPO
TPO 1 : Always moves to a tool–change position even when the same tool is
used in continuous processes.