
B–63284EN/03
3. CREATING MACHINING PROGRAMS
FOR A LATHE HAVING THE Y–AXIS
MACHINING FUNCTION
TYPES OF MACHINING
PROGRAMS
461
Y
Chuck side
Z
X
End face of a workpiece
[HEAD2]
Note) This figure shows the axes of the
workpiece coordinate system.
The figure above shows a workpiece viewed from the tool side. When a
machining program is created, however, the workpiece is viewed from the
front of the machine; therefore, in the figure above the face to be actually
machined is hidden from view.
To view the side face to be machined, the workpiece must be rotated about
the C–axis by 180 degrees. Consequently, the Y–axis of the actual
workpiece coordinate system is inverted as shown below.
Workpiece coordinate systems for Y–axis machining on the side face
Y
Z
[HEAD1]
Y
Z
[HEAD2]
Since a positive value is always specified as the Z coordinate, the Z–axis
of the program coordinate system is always opposite to that of the
corresponding workpiece coordinate system, as shown below:
Program coordinate systems for Y–axis machining on the side face
Y
Z
[HEAD1]
Y
Z
[HEAD2]
Center drilling, drilling, reaming, and tapping can be specified for Y–axis
drilling on the side face in the same way as for drilling for turning.
3.2
CENTER DRILLING,
DRILLING, REAMING,
AND TAPPING
(ON THE SIDE FACE)