
B–63284EN/03
1. MACHINING PROGRAMS FOR
2–AXES (X AND Z–AXIS) LATHES
TYPES OF MACHINING
PROGRAMS
329
Thread lead
The least input increment is 0.0001 mm
or 0.000001 inch.
Number of threads per inch
The least input increment is 0.1.
Management number of a threading tool
Cutting feedrate for threading
Depth of cut for the first pass
By pressing [CUT–NMBR], the number
of cuts can be specified, instead of a
depth of cut, for the first pass.
1. When CUT–DPTH is selected
Specify a depth of cut for the first
pass. The number of cuts is
determined from the depth of cut and
the cutting method.
2. When CUT–NMBR is selected
The number of cuts is calculated from
the depth of cut determined by the au-
tomatic cutting condition determina-
tion function when the LEAD data
item is specified.
When the number of cuts is entered,
threading is performed according to
the specified number of cuts. This
number of cuts includes the spark–
out operations.
NOTE
1 The maximum number of cuts is 999. If CUT–NMBR is
selected for the first time after the creation of a threading
process, the number of cuts is automatically calculated after
data has been entered for the LEAD item.
2 When specifying zigzag cutting as the cutting method,
specify an even number of cuts, excluding the number of
spark–out operations. If an odd number of cuts is specified,
one extra cutting operation is performed.
3 Depending on the minimum depth of cut (set in parameter
No. 9833), the specified number of cuts may be greater than
actually needed. In such a case, the actual number of cuts
is reduced to a value below the specified number.
Furthermore, the specified number of cuts may differ slightly
from the actual number of cuts because of a degree of error
in the calculation.
LEAD (General–purpose/
metric thread)
THRD CNT/INCH
(UNIFIED/PT/PF THRED)
TOOL–NO
CUT–SPD (M/minute)
CUT–DPTH
(CUT–NMBR)