
1. MACHINING PROGRAMS FOR
2–AXES (X AND Z–AXIS) LATHES
B–63284EN/03
TYPES OF MACHINING
PROGRAMS
290
(4) Details of machining
If the parameter for null cutting cancel is set, and the formed material
is specified as the material figure, the bar machining process is
executed, thereby automatically canceling cutting where there is no
material.
(a) Machining the outer surface of a bar
Cutting path
Rapid traverse path
Product figure
Material figure
(b) Machining a recessed outer surface of a bar
When outer surface, inner surface, or end face + automatic
residual machining is specified, the middle portion is cut with the
tool–tip geometry compensation as shown below. For other
portions, null cutting is canceled as with ordinary outer surface,
inner surface, or end face machining.
The portion which was left uncut in the middle portion is
automatically cut by the left–hand tool during automatic residual
machining.
Example of machining a recessed outer surface of a bar)
Middle portion
Inner–surface bar machining and end–face bar machining are executed in
the same way as outer–surface bar machining.